Neighbor Route-Reflector-Client - Dell S4810 Reference Manual

Defaults Not configured.
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
When you apply a route map to outbound routes, only routes that match at least
Information
one section of the route map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the
characteristics in the Route map used in this command. If you identify a peer by IP
address, the Route map overwrites either the inbound or outbound policies on that
peer.

neighbor route-reflector-client

Configure the router as a route reflector and the specified neighbors as members of the cluster.
S4810
Syntax
neighbor {ip-address | peer-group-name} route-reflector-client
To remove one or more neighbors from a cluster, use the no neighbor {ip-
address | peer-group-name} route-reflector-client command. If you
delete all members of a cluster, you also delete the route-reflector configuration
on the router.
Parameters
ip-address
peer-group-
name
432
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Enter the IP address of the neighbor in dotted decimal
format.
Enter the name of the peer group.
All routers in the peer group receive routes from a route
reflector.
Border Gateway Protocol