Bgp Router-Id; Clear Ip Bgp - Dell S4810 Reference Manual

bgp router-id

Assign a user-given ID to a BGP router.
S4810
Syntax
bgp router-id ip-address
To delete a user-assigned IP address, use the no bgp router-id command.
Parameters
ip-address
Defaults The router ID is the highest IP address of the Loopback interface or, if no Loopback
interfaces are configured, the highest IP address of a physical interface on the
router.
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Usage
Peering sessions are reset when you change the router ID of a BGP router.
Information
This command automatically restarts the BGP instance for the configuration to
take effect.

clear ip bgp

Reset BGP sessions. The soft parameter (BGP Soft Reconfiguration) clears the policies without resetting
the TCP connection.
S4810
Syntax
clear ip bgp [vrf vrf-name] * | as-number | ip-address [flap-
statistics | soft [in | out]]
Border Gateway Protocol
Enter an IP address in dotted decimal format to reset only
that BGP neighbor.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
397