Show Bfd Neighbors - Dell S4810 Reference Manual

Defaults none
Command ROUTER BGP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version 9.0.0.0
Version
8.3.19.0
Version 8.3.8.0
Version 8.4.1.3
Usage
When you explicitly disable a BGP neighbor for a BFD session with the neighbor
Information
bfd disable command:
•
•
When you remove the Disabled state of a BFD for a BGP session with a specified
neighbor by entering the no neighbor bfd disable command, the BGP link
with the neighbor returns to normal operation and uses the BFD session
parameters globally configured with the bfd neighbor command or configured
for the peer group to which the neighbor belongs.
Related
neighbor bfd
Commands
group.

show bfd neighbors

Display BFD neighbor information on all interfaces or a specified interface.
S4810
Syntax
show bfd neighbors interface [detail]
Parameters
interface
Bidirectional Forwarding Detection (BFD)
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
The neighbor does not inherit the global BFD disable values configured with the
bfd neighbor command or configured for the peer group to which the
neighbor belongs.
The neighbor only inherits the global timer values configured with the bfd
neighbor command: interval, min_rx, and multiplier.
— Explicitly enables a BFD session with a BGP neighbor or a BGP peer
Enter one of the following keywords and slot/port or number
information:
369