Show Interface Pfc Statistics - Dell S4810 Reference Manual

show interface pfc statistics

Displays counters for the PFC frames received and transmitted (by dot1p priority class) on an interface.
S4810
Syntax
show interface port-type slot/port pfc statistics
Parameters
port-type
slot/port
Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version
8.3.12.0
Version
8.3.16.0
Example
Dell (conf-if-te-0/1)#show int te 0/1 pfc statistics
(Summary)
Interface TenGigabitEthernet 0/1
Priority
Frames
---------------------------------------------------------------
-----------------------
-
530
Admin is enabled
Remote is enabled
Remote Willing Status is enabled
Local is enabled
Oper status is recommended
PFC DCBX Oper status is Up
State Machine Type is Feature
TLV Tx Status is enabled
PFC Link Delay 45556 pause quanta
Application Priority TLV Parameters :
--------------------------------------
FCOE TLV Tx Status is disabled
ISCSI TLV Tx Status is disabled
Local FCOE PriorityMap is 0x8
Local ISCSI PriorityMap is 0x10
Remote FCOE PriorityMap is 0x8
Remote ISCSI PriorityMap is 0x8
0 Input TLV pkts, 1 Output TLV pkts, 0 Error pkts,
0 Pause Tx pkts, 0 Pause Rx pkts
Enter the port type.
Enter the slot/port number.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
Tx Total Frames
Rx XOFF Frames Rx Total
Data Center Bridging (DCB)