ip address
Defaults
Not configured.
Command
CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
ip max-frag-count
Set the maximum number of fragments allowed in one packet for packet re-assembly.
Z9500
Syntax
ip max-frag-count count
To place no limit on the number of fragments allowed, use the no ip max-frag-
count command.
Parameters
count
Defaults
No limit is set on number of fragments allowed.
Command
CONFIGURATION
Modes
IPv4 Routing
Enter an IP address, in dotted decimal format, to be mapped
to the name.
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced for the E-Series.
Enter a number for the number of fragments allowed for re-
assembly. The range is from 2 to 256.
949