Dell S4810 Reference Manual page 505

Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Usage
This command applies to both IPv4 and IPv6 CAM Profiles, but is best used when
Information
verifying QoS optimization for IPv6 ACLs.
QoS Optimization for IPv6 ACLs does not impact the CAM usage for applying a
policy on a single (or the first of several) interfaces. It is most useful when a policy
is applied across multiple interfaces; it can reduce the impact to CAM usage across
subsequent interfaces.
The following describes the test cam-usage command shown in the following
example.
Term
Stack-Unit
Portpipe
CAM Partition
Available CAM
Estimated CAM
per Port
Status
Example (S-
Dell#test cam-usage service-policy input In stack-unit all
Series)
Stack-Unit | Portpipe | CAM Partition | Available CAM |
Estimated CAM per Port| Status
---------------------------------------------------------------
-----------------------
0 | 0 | IPv4Flow | 102 | 0| Allowed
0 | 1 | IPv4Flow | 102 | 0| Allowed
Dell#
!
Dell#test cam-usage service-policy input In stack-unit 0 port-
set 1
Stack-Unit | Portpipe | CAM Partition | Available CAM |
Estimated CAM per Port| Status
---------------------------------------------------------------
------------------------
Content Addressable Memory (CAM)
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced.
Explanation
Lists the stack unit or units that are checked. Entering all
shows the status for all stacks.
Lists the portpipe (port-set) or port pipes (port-sets) that are
checked. Entering all shows the status for linecards and
port-pipes in the chassis.
Shows the CAM profile of the CAM.
Identifies the amount of CAM space remaining for that
profile.
Estimates the amount of CAM space the listed policy will
require.
Indicates whether or not the policy will be allowed in the
CAM.
505