31
ARM DDI 0337G
Unrestricted Access
Note
SYSRESETREQ is cleared by a system reset, which means that asserting
VECTRESET at the same time might cause SYSRESETREQ to be cleared in the
same cycle as it is written to. This might prevent the external system from seeing
SYSRESETREQ. It is therefore recommended that VECTRESET and
SYSRESETREQ be used exclusively and never both written to 1 at the same time.
System Control Register
Use the System Control Register for power-management functions:
•
signal to the system when the processor can enter a low power state
•
control how the processor enters and exits low power states.
The register address, access type, and Reset state are:
Address
0xE000ED10
Access
Read/write
Reset state
0x00000000
Figure 8-12 shows the bit assignments of the System Control Register.
Copyright © 2005-2008 ARM Limited. All rights reserved.
Reserved
Figure 8-12 System Control Register bit assignments
Non-Confidential
Nested Vectored Interrupt Controller
5
4 3 2 1 0
SEVONPEND
Reserved
SLEEPDEEP
SLEEPONEXIT
Reserved
8-25