Table of Contents
Advertisement
ARM DDI 0337G
Unrestricted Access
in turn acknowledges the PMU. When all acknowledges are set, then the next
SLEEPDEEP mode is agreed to be a WIC mode sleep. Figure 7-3 shows an example of
this hand-shaking sequence.
FCLK
WICENREQ
WICENACK
WICDSREQn
WICDSACKn
The next time the deep sleep mode is entered either by WFI, WFE, or sleep-on-exit then
the processor loads the WIC with a suitable mask using WICLOAD and WICMASK to
enable the required interrupts and events, or both, to cause a wake-up. A logic-1 in the
WICSENSE and WICMASK vector, or both, indicates that the WIC must wake up in
response to the corresponding WICINT signal. The mask vector is held by the WIC
when programmed. WICPEND is a vector of pending interrupts captured by the WIC
block. This provides a latched indication of the occurrence of any enabled and detected
interrupts which occurred while the NVIC was sleeping. This enables pulse-interrupts
to be used in combination with WIC based sleep methods.
The PMU must assert SLEEPHOLDREQn to prevent the processor from waking up
during a power-down sequence. When it has been acknowledged by
SLEEPHOLDACKn then the PMU can proceed to power down the system. When the
WIC detects a wake-up trigger from an interrupt or an event then it signals to the PMU
to power up the processor using the WAKEUP pin. When the power is restored, the
processor processes the event or interrupts or both given by the WICPEND signal that
has stored the interrupts that have occurred including ones that do not cause a wake-up
event because their priorities are not sufficient. When awake, the processor asserts
WICLEAR to clear the mask contents stored in the WIC. The processor then proceeds
with executing instructions until another WIC mode sleep event occurs.
Figure 7-4 on page 7-8 shows an example of the previously described functionality. It
also shows the driving of ISOLATEn, RETAINn and PWRDOWN for use with state
retention cells.
Copyright © 2005-2008 ARM Limited. All rights reserved.
Figure 7-3 WIC mode enable sequence
Non-Confidential
Power Management
7-7
Advertisement
Table of Contents
