Hino S5-LJ05E04A Workshop Manual page 644

17–10
COOLANT PIPE F
TURBOCHARGER
ASSEMBLY
COOLANT
PIPE E
OIL COOLER
ASSEMBLY
FOLDER
OIL PIPE B
GASKET
OIL PIPE A
TURBOCHARGER (J05E)
6.
(1)
! CAUTION
•
•
(2)
SHTS021271600017
(3)
! CAUTION
•
•
(4)
SHTS021271600018
7.
(1)
GASKET
! CAUTION
•
•
SHTS021271600019
(2)
TURBOCHARGER
ASSEMBLY
! CAUTION
•
•
SHTS021271600020
MOUNTING THE COOLANT PIPE
Replace with the new gaskets and mount the coolant pipe F to the
turbocharger assembly and thermostat case with 2 union bolts.
Clean the coolant pipe and check the pipe for collapse and
dirt and foreign matters inside.
Do not use any sealant on the coolant pipe installation sur-
face to avoid defects such as damage by clogging or loosen-
ing at the tightening portion.
Mount the clip with the nut and secure coolant pipe F.
Replace with the new gaskets and connect the coolant pipe E to
the folder and turbocharger assembly with 2 union bolts.
Clean the coolant pipe and check the pipe for collapse and
dirt and foreign matters inside.
Do not use any sealant on the coolant pipe installation sur-
face to avoid defects such as damage by clogging or loosen-
ing at the tightening portion.
Mount the clip with the nut and secure coolant pipe E.
MOUNTING THE OIL PIPE
Replace with the new gaskets and connect the oil pipe B to the
turbocharger assembly and cylinder block with 4 bolts.
Clean the oil pipe and check the pipe for collapse and dirt
and foreign matters inside.
Do not use any sealant on the oil pipe installation surface to
avoid defects such as damage by clogging or loosening at
the tightening portion.
Replace with the new gaskets and connect the oil pipe A to the
turbocharger assembly and oil cooler assembly with a bolt and 2
union bolts.
Clean the oil pipe and check the pipe for collapse and dirt
and foreign matters inside.
Do not use any sealant on the oil pipe installation surface to
avoid defects such as damage by clogging or loosening at
the tightening portion.