Hino S5-LJ05E04A Workshop Manual page 381

CONCAVE CRANKSHAFT
PART BEARING
ENGINE MECHANICAL (J05E)
(3) Remove the crankshaft bearing mounted to the cylinder block.
PUSH
! CAUTION
The removed crankshaft bearings must be identified and stored in
order of cylinder number.
NOTICE
Press the one end of the crankshaft bearing at the opposite side
of the concave with fingers to facilitate removal.
SHTS021270900247
INSPECTING THE COMPONENTS
1. INSPECTING THE ROTATION RUNOUT
(1) Use the dial gauge to measure crankshaft revolution runout. If a
measurement reading exceeds the repair limit, replace the crank-
shaft.
SHTS021270900248
Standard value (mm {in.})
0-0.1 {0-0.0039}
10–105
Repair limit (mm {in.})
0.15 {0.0059}