Hino S5-LJ05E04A Workshop Manual page 120

MOUNTING AND DISMOUNTING THE ENGINE (J05E)
1. PREPARATION BEFORE MEASUREMENT
(1) Fully charge the battery.
(2) Inspect the valve clearance. When it exceeds the standard value,
adjust it.
Reference: MOUNTING AND DISMOUNTING THE ENGINE
(J05E), ENGINE ASSEMBLY, ADJUSTING THE VALVE
CLEARANCE (Page 5-5)
Warm up the engine and set the coolant temperature to 80 C
(3)
{176 F}.
(4) Remove the air cleaner.
Reference: INTAKE (J05E), AIR CLEANER, REPLACEMENT,
MOUNTING THE AIR CLEANER ELEMENT AND BODY
ASSEMBLY (Page 9-23)
(5) Remove the all glow plugs.
Reference: ENGINE MECHANICAL (J05E), GLOW PLUG,
REPLACEMENT, REMOVING THE GLOW PLUG (Page 10-129)
(6) Remove the 4 bolts from the glow plug hole.
(7) Disconnect the all connectors of each injector.
Reference: FUEL SYSTEM (J05E), INJECTOR, REPLACE-
MENT, REMOVING THE INJECTOR (Page 7-37)
(8) Connect the battery negative terminal.
! CAUTION
To prevent a short circuit in the wiring, wrap the power wiring with
vinyl tape.
(9) Turn the starter to discharge the foreign matter in the cylinder.
5–3