Honda Accord 2008 Manual page 388

07/11/02 09:02:37 61TA0000_110_0069
DTC P0102:
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information (see page 11-3).
1. Turn the ignition switch to ON (II), and wait
2 seconds.
2. Check the MAF SENSOR in the DATA LIST with the
HDS.
Is about 0 gm/ s, or 0.1 V or less indicated?
YES
NO −
time. Check for poor connections or loose terminals
at the MAF sensor and the ECM/PCM.
3. Turn the ignition switch to LOCK (0).
4. Disconnect the MAF sensor/IAT sensor 5P
connector.
5. Turn the ignition switch to ON (II).
6. Measure voltage between MAF sensor/IAT sensor
5P connector terminal No. 3 and body ground.
＊０１
Is there battery voltage?
YES
NO −
relay 1 and the MAF sensor, then go to step 19.
MAF Sensor Circuit Low Voltage
−
Go to step 3.
Intermittent failure, the system is OK at this
MAF SENSOR/IAT SENSOR 5P CONNECTOR
IGP (YEL/BLK)
Wire side of female terminals
− Go to step 7.
Repair open in the wire between PGM-FI main
7. Turn the ignition switch to LOCK (0).
8. Measure resistance between MAF sensor/IAT
sensor 5P connector terminal No. 1 and body
ground.
MAF SENSOR/IAT SENSOR 5P CONNECTOR
VG ＋ (RED/BLK)
Wire side of female terminals
Is there 190 210 k ?
−
YES − Go to step 13.
NO − Go to step 9.
9. Jump the SCS line with the HDS.
ＴＡ０８ＡＥＡＫ７２１０００９０１０２ＦＡＡＴ３０
＊０２
(cont'd)
11-69