07/11/02 09:02:39 61TA0000_110_0075
12. Turn the ignition switch to LOCK (0).
13. Jump the SCS line with the HDS.
14. Disconnect ECM/PCM connector C (49P).
15. Check for continuity between MAP sensor 3P
connector terminal No. 2 and body ground.
*03
Is there continuity?
YES
PCM (C11) and the MAP sensor, then go to step 18.
NO
−
16. Turn the ignition switch to LOCK (0).
17. Replace the MAP sensor (see page 11-227).
18. Reconnect all connectors.
19. Turn the ignition switch to ON (II).
20. Reset the ECM/PCM with the HDS.
21. Do the ECM/PCM idle learn procedure (see page
11-343).
MAP SENSOR 3P CONNECTOR
MAP (GRN/RED)
Wire side of female terminals
−
Repair short in the wire between the ECM/
Go to step 23.
22. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P0107 indicated?
YES
−
Check for poor connections or loose
terminals at the MAP sensor and the ECM/PCM,
then go to step 1.
−
NO
Troubleshooting is complete. If any other
Temporary DTCs or DTCs are indicated, go to the
indicated DTC's troubleshooting.
23. Reconnect all connectors.
24. Update the ECM/PCM if it does not have the latest
software (see page 11-231), or substitute a known-
good ECM/PCM (see page 11-7).
25. Check for Temporary DTCs or DTCs with the HDS.
Is DT C P0107 indicated?
YES
−
Check for poor connections or loose
terminals at the MAP sensor and the ECM/PCM. If
the ECM/PCM was updated, substitute a known-
good ECM/PCM (see page 11-7), then recheck. If the
ECM/PCM was substituted, go to step 1.
NO
−
If the ECM/PCM was updated, troubleshooting
is complete. If the ECM/PCM was substituted,
replace the original ECM/PCM (see page 11-232). If
any other Temporary DTCs or DTCs are indicated,
go to the indicated DTC's troubleshooting.
11-75