Abort[1]|2] - Agilent Technologies EPM-P Series Programming Manual

ABORt[1]|2]

This command removes the specified channel from the wait for trigger
state and places it in the idle state. It does not affect any other settings of
the trigger system. When the INITiate command is sent, the trigger
system responds as it did before ABORt was executed.
If INITiate:CONTinuous is ON, then after ABORt the specified channel
immediately goes into the wait for trigger state.
Syntax
ABOR
Example
ABOR
EPM-P Series Power Meters Programming Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
1
2
This command places channel A in
the idle state.
TRIGger Subsystem
ABORt[1]|2]
13-3