Agilent Technologies EPM-P Series Programming Manual page 221

CALCulate Subsystem
CALCulate[1]|2|3|4:FEED[1]|2 <string>
Query Example
CALC1:FEED2?
Error Message
• If the command is used when no sensor is attached, error -241
"Hardware missing" occurs.
• If <string> contains ON SWEEP[1]|2|3|4 and the feed's
TRIG:SOUR is not INT or EXT (for single channel power meters) or
INT1, INT2 or EXT (for dual channel power meters), error -221 "Settings
conflict" occurs.
• If the command changes the measurement mode to PEAK or PTAV when
a non E9320 sensor is connected or an E9320 sensor is connected and
set to AVERage mode rather than NORMal mode, error -221, "Settings
Conflict" occurs.
3-6
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
This command queries the current
setting of the data_handle on
FEED2 of the upper
window/upper measurement.
EPM-P Series Power Meters Programming Guide