Status Register Set Commands - Agilent Technologies EPM-P Series Programming Manual

Power meters

Hide thumbs Also See for EPM-P Series:

Table of Contents

STATus Subsystem

Status Register Set Commands

This section describes the five status register set commands. Each can be

used to examine all of the eleven status registers listed on the previous

To apply a command to a specific register, prefix the command with the

name of the appropriate register. For example, to apply the :ENABle

command to the STATus:QUEStionable register, use the following

STATus:QUEStionable:ENABle.

The Status Register Set commands detailed in this section are:

:NTRansition

:PTRansition

This query returns a 16 bit decimal-weighted number representing the

bits set in the Condition Register of the SCPI Register Set you require to

control. The format of the return is <NR1> in the range of 0 to 32767

-1). The contents of the Condition Register remain unchanged after it

This query returns a 16 bit decimal-weighted number representing the

bits set in the Event Register of the SCPI Register Set you require to

control. The format of the return is <NR1> in the range of 0 to 32767

-1). This query clears all bits in the register to 0.

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Parameter Form

[query only]

EPM-P Series Power Meters Programming Guide

Table of Contents