Agilent Technologies EPM-P Series Programming Manual page 115

Power Meter Remote Operation
Status Reporting
Operation Status
The Operation Status group monitors conditions in the power meter's
measurement process.
The Operation status model is shown in the pullout at the end of this
chapter.
The following bits in these registers are used by the power meter:
Bit Decimal
Number Weight
0 1
1 - 3 -
4 16
5 32
6 - 9 -
10 1024
11 2048
12 4096
13 to 14 -
15 -
The condition bits are set and cleared under the following conditions:
Bit
Meaning
Number
0 CALibrating
1-90
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Definition
CALibrating Summary
Not used
MEASuring Summary
Waiting for TRIGger Summary
Not used
SENSe Summary
Lower Limit Fail Summary
Upper Limit Fail Summary
Not used
Not used (always 0)
EVENts Causing Bit Changes
This is a summary bit for the Operation CALibrating
Register.
• SET: At beginning of zeroing
(CALibration:ZERO:AUTO ONCE) and at the
beginning of calibration (
). Also for the compound command/query
ONCE
CALibration[:ALL]?
beginning of the zero.
• CLEARED: At the end of zeroing or calibration.
EPM-P Series Power Meters Programming Guide
CALibration:AUTO
, this bit is set at the