Trigger[1]|2[:Immediate] - Agilent Technologies EPM-P Series Programming Manual

TRIGger[1]|2[:IMMediate]

This command causes a trigger to occur immediately, provided the
specified channel is in the wait for trigger state. When this command is
executed, the measurement result is stored in the power meter's memory.
Use FETCh? to place the measurement result in the output buffer.
TRIGger[1]|2:DELay:AUTO is ignored if TRIGger[1]|2[:IMMediate]
is set to ON.
Note This command performs the same function as
INITiate[1]|2:[IMMediate].
Syntax
TRIG
Example
TRIG
Error Messages
If the power meter is not in the wait for trigger state, then
TRIGger:IMMediate causes error -211, "Trigger ignored".
EPM-P Series Power Meters Programming Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
1
:IMM
2
This command causes a channel A
trigger to occur immediately.
TRIGger Subsystem
TRIGger[1]|2[:IMMediate]
13-17