Trace[1]|2:State <Boolean> - Agilent Technologies EPM-P Series Programming Manual

TRACe[1]|2:STATe <boolean>
This command enables or disables trace capture for the specified channel.
Syntax
TRAC
Example
TRAC2:STAT 1
Reset Condition
On reset trace capture is set to OFF.
Query
TRACe[1]|2:STATe?
The query command enters a 1 or 0 into the output buffer indicating
whether or not trace capture is enabled or disabled.
•
•
Query Example
TRAC1:STAT?
Error Messages
• If an E-Series E9320 sensor is not connected, error -241, "Hardware
missing" occurs.
• If an E-Series E9320 sensor is connected and set to AVERage mode
rather than NORMal mode, error –221, "Settings conflict" occurs.
EPM-P Series Power Meters Programming Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
:STAT
1
2
1 is returned when trace capture is enabled.
0 is returned when trace capture is disabled.
TRACe[1]|2:STATe <boolean>
Space 0|OFF
1|ON
?
This command enables trace
capture for channel B.
This command queries the current
state of trace capture for
channel A.
TRACe Subsystem
12-5