Agilent Technologies EPM-P Series Programming Manual page 158

CONFigure[1]|2|3|4[:SCALar][:POWer:AC] [<expected_value>[,<resolution>[,<source list>]]]
Parameters
Refer to "Optional Parameters", on page 2-3 for additional details on the
parameters in this command.
Item
expected_value
resolution
source list
1. The mnemonic
parameter used in the command sub-systems. The parameters must be entered in the
specified order. If parameters are omitted, they will default from the right. The
parameter DEFault is used as a place holder. Specifying
value unchanged.
2. When the measurement result is linear this parameter represents the number of
significant digits. When the measurement result is logarithmic 1 to 4 represents a
resolution of 1, 0.1, 0.01 and 0.001 respectively.
3. E4417A only.
EPM-P Series Power Meters Programming Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Description/Default
A numeric value for the expected
power level. The units of
measurement are dBm and W. The
default units are defined by
UNIT:POWer.
A numeric value for the resolution.
If unspecified the current
resolution setting is used.
The channel which the command
is implemented on.
If unspecified the current window
setup is used. However, on the
E4417A, if the window shows a
ratio or difference measurement,
the upper window defaults to
channel A and the lower window to
channel B.
means DEFault. This is not equivalent to the DEFault
DEF
Measurement Commands
Range of Values
Sensor dependent.
1
DEF
2
1 to 4
1.0, 0.1, 0.01, 0.001
1
DEF
(@1)
3
(@2)
DEF leaves the parameter
2-11