Memory:table Commands - Agilent Technologies EPM-P Series Programming Manual

MEMory Subsystem

MEMory:TABLe Commands

MEMory:TABLe Commands
These commands are used to define a sensor calibration table (8480 Series
power sensors and N8480 Series sensors with Option CFT only) or a
frequency dependent offset table, and to write to and read data from it.
The following commands are described in this section:
MEMory:TABLe:FREQuency <numeric_value>{,<numeric_value>}
MEMory:TABLe:FREQuency:POINts?
MEMory:TABLe:GAIN[:MAGNitude]
<numeric_value>{,<numeric_value>}
MEMory:TABLe:GAIN[:MAGNitude]:POINts?
MEMory:TABLe:MOVE <character_data>,<character_data>
MEMory:TABLe:SELect <character_data>
7-22 EPM-P Series Power Meters Programming Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com