Agilent Technologies EPM-P Series Programming Manual page 225

CALCulate Subsystem
CALCulate[1]|2|3|4:GAIN:STATe <boolean>
CALCulate[1]|2|3|4:GAIN:STATe <boolean>
This command is used on the specified window/measurement to enable
and disable the display offset set by the
CALCulate[1]|2|3|4:GAIN[:MAGNitude] command.
Syntax
CALC
Example
CALC2:GAIN:STAT 1
Reset Condition
On reset, the gain is disabled.
Query
CALCulate[1]|2|3|4:GAIN:STATe?
The query enters a 1 or 0 into the output buffer indicating the status of
the display offset.
•
•
Query Example
CALC1:GAIN:STAT?
3-10
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
:STAT
1 :GAIN
2
3
4
1 is returned when the display offset feature is enabled.
0 is returned when the display offset feature is disabled.
EPM-P Series Power Meters Programming Guide
Space
0|OFF
1|ON
?
This command enables the display
offset for the lower window/ upper
measurement.
This command queries whether
the display offset in the upper
window/upper measurement is on
or off.