Agilent Technologies EPM-P Series Programming Manual page 257

CALibration Subsystem
CALibration[1]|2:AUTO <boolean>
Reset Condition
On reset, automatic calibration is disabled.
Query
CALibration[1]|2:AUTO?
The query always returns a value of 0.
Error Messages
• If the calibration was not carried out successfully the error -231, "Data
Questionable; CAL ERROR" occurs. If you are using the E4417A the
error message specifies which channel the calibration failed on.
• If the command is set to ON the error -224, "Illegal parameter value"
occurs.
• If there is no sensor connected, the error -241, "Hardware Missing"
occurs.
4-8
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
EPM-P Series Power Meters Programming Guide