Agilent Technologies EPM-P Series Programming Manual page 229

CALCulate Subsystem
CALCulate[1]|2|3|4:LIMit:CLEar:AUTo <boolean>|ONCE
Query
CALCulate[1]|2|3|4:LIMit:CLEar:AUTO?
The query command enters a 1 or 0 into the output buffer indicating
whether limit failures are cleared automatically when a new
measurement is initiated on the specified window section.
•
•
In the case where limit failures are cleared once, when a query occurs a 1
is entered into the output buffer if no measurement is initiated. If a
measurement is initiated then 0 is entered.
Query Example
CALC1:LIM:CLE:AUTO?
3-14
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
1 is entered into the output buffer when limit failures are cleared
automatically when a new measurement is initiated.
0 is entered into the output buffer when limit failures are not
cleared automatically when a new measurement is initiated.
EPM-P Series Power Meters Programming Guide
This command queries when the
FCO is cleared for the upper
window/upper measurement.