Agilent Technologies EPM-P Series Programming Manual page 167

Measurement Commands
CONFigure[1]|2|3|4[:SCALar][:POWer:AC]:RATio [<expected_value>[,<resolution>[,<source list>]]]
1. The mnemonic
parameter used in the command sub-systems. The parameters must be entered in
the specified order. If parameters are omitted, they will default from the right. The
parameter DEFault is used as a place holder. Specifying
value unchanged.
2. When the measurement result is linear this parameter represents the number of
significant digits. When the measurement result is logarithmic 1 to 4 represents a
resolution of 1, 0.1, 0.01 and 0.001 respectively.
3. E4417A only.
Example
CONF1:RAT DEF,4,(@1),(@2)
2-20
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
means DEFault. This is not equivalent to the DEFault
DEF
This command configures the
upper window to make a ratio
measurement of channel A over
channel B, using the current
sensor range and a resolution
setting of 4 on both channels.
EPM-P Series Power Meters Programming Guide
leaves the parameter
DEF