Agilent Technologies EPM-P Series Programming Manual page 557

UNIT[1]|2|3|4:POWer <amplitude_unit>
This command sets the power measurement units for a specified
window/measurement. The power suffix set by UNIT:POWer is used for
any command which accepts a numeric value in more than one unit
For the E4416A:
•
•
•
•
For ratio and relative power measurements:
•
•
Syntax
UNIT
Parameters
Item
amplitude_unit
EPM-P Series Power Meters Programming Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
UNIT1:POWer sets the power measurement units for the upper
window/upper measurement.
UNIT2:POWer sets the power measurement units for the lower
window/upper measurement.
UNIT3:POWer sets the power measurement units for the upper
window/lower measurement.
UNIT4:POWer sets the power measurement units for the lower
window/lower measurement.
If UNIT:POWer is W, the measurement units are percentage.
If UNIT:POWer is DBM, the measurement units are dB relative.
:POW
1
2
3
4
Description/Default
The measurement unit.
• The default unit is dBm.
UNIT[1]|2|3|4:POWer <amplitude_unit>
Space amplitude_unit
?
Range of Values
W
DBM
UNIT Subsystem
14-3