Device Status Register Sets - Agilent Technologies EPM-P Series Programming Manual

STATus Subsystem

Device Status Register Sets

Device Status Register Sets
The status registers contain information which give device status
information. The contents of the individual registers of these register sets
may be accessed by appending the commands listed in "Status Register
Set Commands".
The following command descriptions detail the SCPI register you require
to control but do not detail the register set commands.
The one device status register set is:
STATus:DEVice:
The following bits in these registers are used by the power meter:
Bit
Number
0
1
2
3
4
5
6
7-15
14
15
10-8
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Decimal
Definition
Weight
- Not used
2 Channel A sensor connected
4 Channel B sensor connected (E4417A only)
8 Channel A sensor error
16 Channel B sensor error (E4417A only)
32 Channel A sensor Front/Rear
64 Channel B sensor Front/Rear (E4417A only)
- Not used
16384 Front Panel key press
- Bit 15 always 0
EPM-P Series Power Meters Programming Guide