Agilent Technologies EPM-P Series Programming Manual page 228

CALCulate[1]|2|3|4:LIMit:CLEar:AUTo <boolean>|ONCE
This command controls when the FCO (fail counter) is cleared of any limit
failures. The FCO is used to determine the results returned by the
CALCulate[1]|2|3|4:LIMit:FAIL? query.
•
•
•
Syntax
CALC
Example
CALC1:LIM:CLE:AUTO 1
Reset Condition
On reset, both windows and their measurements are set to ON.
EPM-P Series Power Meters Programming Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
CALCulate[1]|2|3|4:LIMit:CLEar:AUTo <boolean>|ONCE
If ON is specified, the FCO is set to 0 each time a measurement is:
Initiated using INITiate[:IMMediate].
■
Initiated using INITiate:CONTinuous ON.
■
Measured using MEASure?
■
Read using READ?
■
If OFF is specified, the FCO is not cleared by the above commands.
If ONCE is specified, the FCO is cleared only after the first
initialization then starts accumulating any limit failures.
1 :LIM :CLE
2
3
4
CALCulate Subsystem
Space 0|OFF
:AUTO
1|ON
ONCE
?
This command switches on
automatic clearing of the FCO for
the upper window/upper
measurement.
3-13