Trace Subsystem - Agilent Technologies EPM-P Series Programming Manual

TRACe Subsystem

TRACe Subsystem
TRACe Subsystem
Note This command can only be used with E9320 Series sensors.
The TRACe subsystem is used to:
•
•
•
There are two pre-defined TRACE blocks:
•
•
The following commands are described in this chapter:
.
Keyword
TRACe[1]|2
[:DATA]?
:STATe
:UNIT
12-2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Specify the type of trace to be captured.
Enable/disable trace capture.
Specify the trace units.
TRACe1: associated with channel A.
TRACe2: associated with channel B.
Parameter Form
<character_data>
<boolean>
<character_data>
EPM-P Series Power Meters Programming Guide
Notes Page
[query only] page 12-3
page 12-5
page 12-6