Agilent Technologies EPM-P Series Programming Manual page 328

Error Messages
• If more than 80 frequencies are in the list, error -108, "Parameter not
allowed" occurs.
• If the frequencies are not entered in ascending order, error -220,
"Parameter error;Frequency list must be in ascending order" occurs.
• If a table has not been specified using the MEMory:TABLe:SELect
command, the data cannot be entered into the table and error -221,
"Settings conflict" occurs.
• If a frequency is sent which is outside of the allowed frequency range,
error -222, "Data out of range" occurs.
EPM-P Series Power Meters Programming Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
MEMory:TABLe:FREQuency <numeric_value>{,<numeric_value>}
MEMory Subsystem
7-25