Status:operation:ulfail[:Summary] - Agilent Technologies EPM-P Series Programming Manual

STATus:OPERation:ULFail[:SUMMary]

The operation status upper limit fail summary register set contains
information on the upper limit fail status of the power meter.
The following bits in these registers are used by the power meter:
Bit
Number
0
1
2
3
4
5
6
7-15
The appropriate bits are set if a channel upper limit test fails or a window
upper limit test fails.
These bits are cleared if a measurement is made and the test is enabled
and passes.
Syntax
STAT
EPM-P Series Power Meters Programming Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Decimal
Definition
Weight
- Not used
2 Channel A ULFail Status
4 Channel B ULFail Status (E4417A only)
8 Upper window ULFail Status
16 Lower window ULFail Status
32 Upper window lower measurement LLFail Status
64 Lower window lower measurement LLFail Status
- Not used
:ULF :SUMM
:OPER
STATus Subsystem
STATus:OPERation:ULFail[:SUMMary]
10-17