Measurement Units - Agilent Technologies EPM-P Series Programming Manual

CALCulate[1]|2|3|4:LIMit:LOWer[:DATA] <numeric_value>
This command enters a value for the lower test limit for the specified
window/measurement used in the CALCulate[1]|2|3|4:LIMit
:FAIL? test. The units used are dependent on the current setting of
UNIT:POWer and CALCulate:RELative:STATe as shown in Table 3-1.
When the measured value is less than the value specified in
CALCulate[1]|2|3|4:LIMit:LOWer[:DATA],
CALCulate[1]|2|3|4:LIMit:FAIL? reports a fail. When the measured
value is greater than or equal to the limit, a fail is not reported.
Measurement Measurement
Mode
Avg, Pk
Single
Pk-Avg
Channel
Ratio Avg, Pk, Pk-Avg
Avg, Pk
Difference
Pk-Avg
Syntax
CALC
1
2
3
4
EPM-P Series Power Meters Programming Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
CALCulate[1]|2|3|4:LIMit:LOWer[:DATA] <numeric_value>
Table 3-1: Measurement Units
CALC:REL:STAT OFF
Type
Linear
Watt
%
%
Watt
%
:LOW :DATA
:LIM
CALCulate Subsystem
CALC:REL:STAT ON
Log Linear
dBm %
dB %
dB %
dBm %
dB %
Space numeric_value
DEF
MIN
MAX
Space
?
MAX
Log
dB
dB
dB
dB
dB
MIN
3-19