Introduction - Agilent Technologies EPM-P Series Programming Manual

Power Meter Remote Operation

Introduction

Introduction
This chapter describes the parameters which configure the power meter
and help you determine settings to optimize performance. It contains the
following sections:
"Configuring the Remote Interface", on page 1-3.
"Zeroing and Calibrating the Power Meter", on page 1-5.
"Making Measurements", on page 1-8.
"Making Measurements on Wireless Communication Standards", on
page 1-24
"Using Sensor Calibration Tables", on page 1-41.
"Using Frequency Dependent Offset Tables", on page 1-51
"Setting the Range, Resolution and Averaging", on page 1-58.
"Setting Offsets", on page 1-62.
"Setting Measurement Limits", on page 1-64.
"Measuring Pulsed Signals", on page 1-68.
"END", on page 1-70.
"Getting the Best Speed Performance", on page 1-71.
"How Measurements are Calculated", on page 1-75.
"Status Reporting", on page 1-76.
"Saving and Recalling Power Meter Configurations", on page 1-96.
"Using Device Clear to Halt Measurements", on page 1-97.
"An Introduction to the SCPI Language", on page 1-98.
"Summary Of Commands", on page 1-107.
"SCPI Compliance Information", on page 1-120.
1-2 EPM-P Series Power Meters Programming Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com