Agilent Technologies EPM-P Series Programming Manual page 488

SYSTem Subsystem
SYSTem:PRESet <character_data>
Command
Gate setup
[SENS[1]]|SENS2:SWE[1]|2|3|4
:OFF:TIME
[SENS[1]]|SENS2:SWE[1]|2|3|4
:TIME
Trigger setup
TRIG[:SEQ[1]|2]:SOUR
INIT:CONT
TRIG[:SEQ]:LEV:AUTO
TRIG[:SEQ]:LEV
TRIG[:SEQ]:SLOP
TRIG[:SEQ]:DEL
TRIG[:SEQ]:HOLD
Step detection
[SENS[1]]|SENS2:AVER:SDET
Trace setup
DISP[:WIND[1]|2]:TRAC:LOW
DISP[:WIND[1]|2]:TRAC:UPP
[SENS[1]]|SENS2:TRAC:OFFS
:TIME <numeric_value>
[SENS[1]]|SENS2:TRAC:TIME
<numeric_value>
11-42
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Setting
Gate 1: 123.5 us Delay between trigger point
Gate 2: 20.123 ms and time gated period.
Gates 3 - 4: 0
Gates 1 - 2: 6.46 ms Length of time gated period for
Gates 3 - 4: 0 time gated measurements.
INT1 Trigger source set up and
acquisition mode continuous
ON
triggering
OFF Disable automatic setting of the
trigger level
-20 dBm Power level
POS Trigger event recognized on
the rising edge of a signal
0 Delay between recognition of
trigger event and start of a
measurement
30 ms Trigger holdoff
0 Step detection disabled
+20 dBm Maximum power
-35 dBm Minimum power
-0.2 ms Delay between delayed trigger
point and the start of the trace
-28 ms Length of the trace
Agilent E4416A/E4417A Programming Guide
Comments