Sense[1]]|Sense2:Average2 Commands - Agilent Technologies EPM-P Series Programming Manual

Power meters

Hide thumbs Also See for EPM-P Series:

Table of Contents

SENSe Subsystem

[SENSe[1]]|SENSe2:AVERage2 Commands

These commands control video averaging, which is used to improve

measurement accuracy, for the E-Series E9320 Power Sensor. They

combine successive measurements to produce a new composite result.

If the commands in this section are used when a non E9320 sensor is

connected, the error -241, "Hardware missing" occurs.

If the commands in this section are used when an E9320 sensor is

connected and set to AVERage mode rather than NORMal mode, the

error -221, "Settings Conflict" occurs.

The following commands are detailed in this section:

[SENSe[1]]|SENSe2:AVERage2:COUNt <numeric_value>

[SENSe[1]]|SENSe2:AVERage2[:STATe] <boolean>

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

EPM-P Series Power Meters Programming Guide

Table of Contents