Agilent Technologies EPM-P Series Programming Manual page 208

MEASure[1]|2|3|4[:SCALar][:POWer:AC]:DIFFerence? [<expected_value>[,<resolution>[,<source
MEASure[1]|2|3|4[:SCALar][:POWer:AC]:DIFFerence?
[<expected_value>[,<resolution>[,<source list>]]]
This command applies to the E4417A power meter only.
This command sets the specified window's measurement function to
difference mode with relative mode off, aborts, configures then initiates
both channel A and B, calculates the difference measurement result and
places the result on the bus. The result is a power based measurement and
is expressed in the units defined by UNIT[1]|2|3|4:POWer.
Syntax
MEAS
:SCAL
1
2
3
Space
4
Parameters
Refer to "Optional Parameters", on page 2-3 for additional details on the
parameters in this command.
Item
expected_value
(for the expected
power level)
resolution
EPM-P Series Power Meters Programming Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
:POW :AC :DIFF
,
expected_value
DEF
Description/Default
The power meter ignores the
numeric value entered in this
parameter. Any value entered is
treated like DEF.
A numeric value for the resolution.
If unspecified the current
resolution setting is used.
Measurement Commands
?
,
resolution
source list
DEF
Range of Values
sensor dependent
1
DEF
2
1 to 4
1.0, 0.1, 0.01, 0.001
1
DEF
list>]]]
2-61