Sre Mapping; Sre <Nrf> - Agilent Technologies EPM-P Series Programming Manual

IEEE488.2 Command Reference
*SRE <NRf>
*SRE <NRf>
The *SRE <NRf> command sets the Service Request Enable register bits.
This register contains a mask value for the bits to be enabled in the Status
Byte Register. A 1 in the Enable Register enables the corresponding bit in
the Status Byte Register; a 0 disables the bit. The parameter value, when
rounded to an integer and expressed in base 2, represents the bits 0 to 5
and bit 7 of the Service Request Enable Register. Bit 6 is always 0.
Table 16-5 shows the contents of this register. Refer to the pullout at the
end of chapter 1 for further information.
Bit
0
1
2
3
4
5
6
7
Syntax
*SRE
Parameters
Type
NRf
16-18
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Table 16-5: *SRE Mapping
Weight
1 Not used
2 Not used
4 Device Dependent
8 QUEStionable Status Summary
16 Message Available
32 Event Status Bit
64 Not used
128 OPERation Status Summary
Space NRf
?
Description/Default
A value used to set the Service Request
Enable Register.
EPM-P Series Power Meters Programming Guide
Meaning
Range of Values
0 - 255