Averaged Readings; Sense[1]]|Sense2:Average:count:auto <Boolean> - Agilent Technologies EPM-P Series Programming Manual

SENSe Subsystem
[SENSe[1]]|SENSe2:AVERage:COUNt:AUTO <boolean>
[SENSe[1]]|SENSe2:AVERage:COUNt:AUTO <boolean>
This command enables and disables automatic averaging. ONCE has no
affect on the power meter.
When the auto filter mode is enabled, the power meter automatically sets
the number of readings averaged together to satisfy the averaging
requirements for most power measurements. The number of readings
averaged together depends on the resolution and the power level in which
the power meter is currently operating. Figure 9-1 lists the number of
readings averaged for each range and resolution when the power meter is
in auto filter mode.
Setting this command to ON automatically sets the
[SENSe[1]]|SENSe2:AVERage:STATe command to ON.
If [SENSe[1]]|SENSe2:AVERage:COUNt:AUTO is set to OFF, the filter
length is set by the [SENSe[1]]|SENSe2:AVERage:COUNt command.
Using the [SENSe[1]]|SENSe2:AVERage:COUNt command
automatically disables automatic averaging.
Auto averaging is enabled by the MEASure:POWer:AC? and
CONFigure:POWer:AC? commands.
9-8
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Figure 9-1: Averaged Readings
Maximum Sensor Power
10 dB
10 dB
10 dB
10 dB
Minimum Sensor Power
EPM-P Series Power Meters Programming Guide
Resolution Setting
1 2 3 4
1 1 1 8
1 1 1 16
1 1 2 32
1 1 16 256
1 8 128 128