Calibration Factor Block Layout - Agilent Technologies EPM-P Series Programming Manual

Calibration Factor Block Layout

Calibration Factor Block Layout
Calibration Factor Block Layout
The following tables provide information on the calibration factor block
layout for E4410 Series, E9300 Series, E9320 Series and N8480 Series
sensors (excluding Option CFT). The information relates to service
commands described in Chapter 15.
Calibration Factor Block Layout: E4410 Series Sensors
E4410 Series Sensors:
No.
Calibration Factor
Bytes
Block Layout
Header:
Power, low 2
Power, high 2
Number of freq. points 2
Bytes per freq. point 1
Freq. LSB weight 2
Header Total:
Cal Factor Table:
Frequency (point '0') 4
1
Cal factor (low power) 2
1
Cal factor (high power) 2
These table entries are repeated as shown for each frequency point
Frequency (point 'N') 4
1
Cal factor (low power) 2
A-2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Contents Data Format Data Range
- 7.8 (signed) -127.9 to +127.9
- 7.8 (signed) -127.9 to +127.9
- 16 bit integer
- -
1000 -
9
- 32 bit fixed 0 to Fhpb* (2^32)
- 2.14 0.25 to 3
- 2.14 0.25 to 3
- 32 bit fixed 0 to Fhpb* (2^32)
- 2.14 0.25 to 3
Units
dBm Power for low power flatness.
dBm Power for high power
flatness.
- None
- None Number of bytes in cal factor
value at each frequency and
power level.
Hertz Fhbp (Freq. Hz per bit).
1 KHz per bit for the cal
factor: 1KHz x 2^32 =
4.3E+12 = 4300 GHz range
None Fhpb = Freq Hz per bit
None Power (in watts) is divided by
this value.
None Power (in watts) is divided by
this value.
None Fhbp = Freq Hz per bit
None Power (in watts) is divided by
this value.
Agilent E4416A/E4417A Programming Guide
Notes