System:preset <Character_Data> - Agilent Technologies EPM-P Series Programming Manual

SYSTem Subsystem
SYSTem:PRESet <character_data>
Parameters
Item
character_data
Example
SYST:PRES DEF
Error messages
• If a non-E-Series power sensor or N8480 Series power sensor with
Option CFT is connected, the command can be used to set the power
meter to Default settings. When non-of the connected sensors is E9320
sensor, attempts to set the power meter to any of the other settings
result in error -241 "Hardware missing: E9320 Series sensor required"
occurring.
• If BLUetooth or CDMAone is selected and an E9322/6A (1.5 MHz
bandwidth) or E9323/7A (5 MHz bandwidth) power sensor is not
connected, error -241 "Hardware missing: Higher bandwidth E9320
sensor required on channel X. Measurements on channel X may be
inaccurate" occurs.
• If WCDMA or CDMA2000 is selected and an E9323/7A (5 MHz
bandwidth) power sensor is not connected, error -241 "Hardware
missing: Higher bandwidth E9320 sensor required on channel X.
Measurements on channel X may be inaccurate" occurs.
• If two E9320 power sensors are connected to a dual channel power
meter and only one is of sufficient bandwidth to support the selected
format, error -241 "Hardware missing: Higher bandwidth E9320 sensor
11-30
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Description/Default
A communications format which
determines the preset values. Refer to
Tables 11.1 to 11.25 for the preset values
for each format.
This command presets the power meter with
default values. The same default values are
set when the parameter is omitted.
Agilent E4416A/E4417A Programming Guide
Range of Values
DEfault
GSM900
EDGE
NADC
BLUetooth
CDMAone
WCDMA
CDMA2000
IDEN