Sense[1]]|Sense2:Correction:dcycle|Gain3:State Boolean> - Agilent Technologies EPM-P Series Programming Manual

[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3:STATe <boolean>
This command is used to enable and disable the pulse power
measurement feature.
The [SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3 command
should be used to enter the duty cycle of the signal you want to measure.
Syntax
SENS
1
SENS2
Example
CORR:DCYC:STAT 1
Reset Condition
On reset, the pulse power measurement feature is disabled.
Query
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3:STATe?
The query enters a 1 or 0 into the output buffer indicating the status of
the pulse power measurement feature.
•
•
Query Example
CORR:GAIN3:STAT?
EPM-P Series Power Meters Programming Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3:STATe <boolean>
:
:DCYC
CORR
:GAIN3
1 is returned when the pulse power measurement feature is
enabled.
0 is returned when the pulse power measurement feature is
disabled.
SENSe Subsystem
:STAT Space
0|OFF
1|ON
This command enables the pulse
measurement feature on
channel A.
This command queries whether
the pulse measurement feature is
on or off.
?
9-33