Agilent Technologies EPM-P Series Programming Manual page 377

SENSe Subsystem
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2 Commands
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2 Commands
These commands are used to select the active sensor calibration table
(using CSET1) and the active frequency dependent offset table (using
CSET2).
Note If any of the CSET1 commands are used when an E-Series power
sensor or N8480 Series power sensor (excluding Option CFT) is
connected, the error -241, "Hardware missing" occurs.
The following commands are detailed in this section:
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2
[:SELect] <string>
[SENSe[1]]|SENSe2:CORRection:CSET[1]|CSET2:STATe
<boolean>
9-24
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
EPM-P Series Power Meters Programming Guide