Calculate[1]|2|3|4:Gain Commands - Agilent Technologies EPM-P Series Programming Manual

SERV:SENS:TYPE?
SENS:FREQ:800MHZ
SENS:BW:VID:LOW
SENS:SWE1:OFFS:TIME:0.0001235
SENS:SWE1:TIME0.0064
SENS:SWE2:OFFS:TIME:0.020123
SENS:SWE2:TIME0.0064
INIT:CONT ON
TRIG:SOUR INT
TRIG:LEV:AUTO OFF
TRIG:LEV -20.00DBM
TRIG:HOLD 0.03
DISP:WIND1:TRACE:LOW -35
DISP:WIND1:TRACE:UPP 20
SENS:TRAC:OFFS:TIME -0.0002
SENS:TRAC:TIME 0.028
DISP:WIND1:FORM TRACE
DISP:WIND2:FORM DNUM
EPM-P Series Power Meters Programming Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Making Measurements on Wireless Communication Standards
Power Meter Remote Operation
The sensor type query
should return one of the
following:
E9321A|E9322A|E9323A|
E9325A|E9326A|E9327A
The NADC setup is only
valid with these sensors
Sets the measurement
frequency to 800 MHz
Select low video bandwidth
Sets gate1 start point to
123.5 μs after the trigger
Sets gate1 length to 6.4 ms
Sets gate2 start point to
20.123 ms after the trigger
Sets gate2 length to 6.4 ms
Puts meter in "wait for
trigger" state
Selects internal trigger
Turn off auto leveling for
trigger
Sets trigger level to
-20.0 dBm
Sets trigger hold-off to
30 ms
Sets trace display minimum
power to -35 dBm
Sets trace display maximum
power to +20 dBm
Trace starts 200 μs before
trigger point
Trace span set to 28 ms
Assigns upper window to a
trace display
Assigns lower window to a
dual numeric display
1-29