Agilent Technologies EPM-P Series Programming Manual page 166

CONFigure[1]|2|3|4[:SCALar][:POWer:AC]:RATio [<expected_value>[,<resolution>[,<source list>]]]
CONFigure[1]|2|3|4[:SCALar][:POWer:AC]:RATio
[<expected_value>[,<resolution>[,<source list>]]]
This command sets the measurement function, range and resolution of the
specified window. It sets the measurement function to ratio with relative
mode off.
Syntax
CONF
:SCAL
1
2
3
Space
4
Parameters
Refer to "Optional Parameters", on page 2-3 for additional details on the
parameters in this command.
Item
expected_value
(for the expected
power level)
resolution
source list
EPM-P Series Power Meters Programming Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
:POW :AC :RAT
,
expected_value
DEF
Description/Default
The power meter ignores the
numeric value entered in this
parameter. Any value entered is
treated like DEF.
A numeric value for the resolution.
If unspecified the current
resolution setting is used.
This channel list specifies the
channels used to calculate the
ratio. If unspecified and the
current window setup is a ratio
measurement then this ratio setup
is used, otherwise it defaults to
channel A/B (E4417A) or A/A
(E4416A).
Measurement Commands
,
resolution
source list
DEF
Range of Values
sensor dependent
1
DEF
2
1 to 4
1.0, 0.1, 0.01, 0.001
1
DEF
3
(@1),(@2)
3
(@2),(@1)
(@1),(@1)
3
(@2),(@2)
2-19