Agilent Technologies EPM-P Series Programming Manual page 231

CALCulate Subsystem
CALCulate[1]|2|3|4LIMit:FAIL?
CALCulate[1]|2|3|4LIMit:FAIL?
This query enters a 1 or 0 into the output buffer indicating whether there
have been any limit failures for the specified window. A limit failure is
defined as CALC[1]|2|3|4:LIMit:FCO? being non-zero. The FCO (fail
counter) can be zeroed using the CALC[1]|2|3|4:LIMit:CLEar
command.
•
•
Syntax
CALC
Example
CALC1:LIM:FAIL?
Reset Condition
On reset, the buffer is set to zero for both upper and lower window
measurements.
3-16
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
1 is returned when one or more limit failures have occurred.
0 is returned when no limit failures have occurred.
1 :LIM :FAIL
2
3
4
EPM-P Series Power Meters Programming Guide
?
This command queries if there
have been any limit failures on the
upper window/upper
measurement.