Agilent Technologies EPM-P Series Programming Manual page 619

E4410 Series Sensors:
No.
Calibration Factor
Bytes
Block Layout
1
Cal factor (high power) 2
Table Size: -
Calibration Factor Block Layout: E9300 Series Sensors
E9300 Series Sensors:
No.
Calibration Factor
Bytes
Block Layout
Header:
Number of tables 1
Number of freq. points 2
Bytes per freq. point 1
Freq. LSB weight 2
Header Total:
For Each Table (tables are in the order of lower to upper):
Power, low 2
Power, high 2
Frequency (point '0') 4
1
Cal factor (low power) 2
Agilent E4416A/E4417A Programming Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Contents Data Format Data Range
- 2.14 0.25 to 3
1
See note
Contents Data Format Data Range
2
- 16 bit integer
- -
1000
6
- 7.8 (signed) -127.9 to +127.9
- 7.8 (signed) -127.9 to +127.9
- 32 bit fixed 0 to Fhpb* (2^32)
- 2.14 0.25 to 3
Calibration Factor Block Layout
Calibration Factor Block Layout
Units Notes
None Power (in watts) is divided by
this value.
The table size is dependent on
the number of freq. points.
Units Notes
None Number of cal factor tables.
Note that the power levels
and freq. points will be the
same for all tables.
None
- None Number of bytes in cal factor
value at each frequency and
power level.
- Hertz Fhbp (Freq. Hz per bit).
1 KHz per bit for the cal
factor: 1KHz x 2^32 =
4.3E+12 = 4300 GHz range.
dBm Power for low power flatness.
dBm Power for high power
flatness.
None Fhpb = freq Hz per bit
None Power (in watts) is divided by
this value.
A-3