Agilent Technologies EPM-P Series Programming Manual page 387

SENSe Subsystem
[SENSe[1]]|SENSe2:CORRection:DCYCle|GAIN3:STATe <boolean>
Error Messages
• If [SENSe[1]]|SENSe2:CORRection:DCYCle:STATus is set to ON
while [SENSe[1]]|SENSe2:SPEed is set to 200, the error -221,
"Settings Conflict" occurs.
• If this command is used when an E4410 E-Series powers sensor is
connected, the error -310, "System error;Dty Cyc may impair accuracy
with ECP sensor" occurs. If you are using the E4417A the error message
specifies the channel.
9-34
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
EPM-P Series Power Meters Programming Guide