Default: Power Meter Presets; Preset Values - Agilent Technologies EPM-P Series Programming Manual

required on channel X. Measurements on channel X may be inaccurate"
occurs.

Preset Values

DEFault
The following table shows the power meter presets when
<character_data> is set to DEFault or omitted. Values are shown for
all SCPI commands:
Table 11-1: DEFault: Power Meter Presets
Command
CALC[1]|2|3|4:FEED[1]|2
CALC[1]|2|3|4:GAIN[:MAGN]
CALC[1]|2|3|4:GAIN:STAT
CALC[1]|2|3|4:LIM:CLE:AUTO
CALC[1]|2|3|4:LIM:LOW[:DATA]
CALC[1]|2|3|4:LIM:STAT
CALC[1]|2|3|4:LIM:UPP[:DATA]
CALC[1]|2|3|4:MATH[:EXPR]
CALC[1]|2|3|4:REL[:MAGN]:AUTO
CALC[1]|2|3|4:REL:STAT
CAL[1]|2:ECON:STAT
CAL[1]|2:RCAL
CAL[1]|2:RCF
DISP:CONT
DISP:ENAB
DISP:SCR:FORM
DISP[:WIND[1]|2]:ANAL:LOW
DISP[:WIND[1]|2]:ANAL:UPP
Agilent E4416A/E4417A Programming Guide
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
SYSTem:PRESet <character_data>
Setting
"POW:AVER" Select average measurement
type
0.000 dB Display offset value
OFF Display offset disabled
ON Clear limit data at INIT
-90 dBm Lower limit
OFF Window limits checking disabled
+90 dBm
Agilent E4416A: Math expression
Upper - channel A
Lower - channel A
Agilent E4417A
Upper - channel A
Lower - channel B
OFF Reference value disabled
OFF Relative offset disabled
OFF TTL zero/calibration inputs
disabled
not affected zero/cal lockout
100.0% Reference calibration factor
not affected Display contrast
ON Display enabled
WIND Display format set to windowed
-70 dBm Lower scale limit
20 dBm Upper scale limit
SYSTem Subsystem
Comments
11-31