Agilent Technologies EPM-P Series Programming Manual page 309

MEMory Subsystem
MEMory:CATalog[:ALL]?
The power meter is shipped with a set of predefined sensor calibration
tables. The data in these sensor calibration tables is based on statistical
averages for a range of Agilent Technologies power sensors. These tables
can be altered. The predefined data is listed in your User's Guide. These
power sensors are:
Table
0
1
2
3
4
5
6
7
8
9
1. Default is a sensor calibration table in which the reference
calibration factor and calibration factors are 100%. This sensor
calibration table can be used during the performance testing of
the power meter.
There are also ten sensor calibration tables named CUSTOM_0 through
CUSTOM_9 and ten frequency dependent offset tables named
CUSTOM _A through CUSTOM _J which do not contain any data when
the power meter is shipped from the factory.
Syntax
MEM
Example
MEM:CAT?
7-6
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Power Sensor
None
8481A
8482A, 8482B, 8482H
8483A
8481D
8485A
R8486A
Q8486A
R8486D
8487A
:CAT :ALL
?
EPM-P Series Power Meters Programming Guide
Table Name
1
DEFAULT
HP8481A
HP8482A
HP8483A
HP8481D
HP8485A
R8486A
Q8486A
R8486D
HP8487A
This command queries the list of
tables and save/recall registers.