Agilent Technologies EPM-P Series Programming Manual page 222

CALCulate Subsystem
CALCulate[1]|2|3|4:GAIN Commands
CALCulate[1]|2|3|4:GAIN Commands
These commands are used to enter and enable a display offset on the
specified window/measurement. The display offset is applied to the
measurement signal after any math calculation.
The following commands are detailed in this section:
CALCulate[1]|2|3|4:GAIN[:MAGNitude] <numeric value>
CALCulate[1]|2|3|4:GAIN:STATe <boolean>
EPM-P Series Power Meters Programming Guide 3-7
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com